| High performance, deep-search, target-ID metal detector at a very affordable price. The Fisher CZ-5 QuickSilver has it all: Visual target ID meter, three-tone audio target ID, big-target alert, depth reading, pushbutton pinpointing, wet-sand operation, deep-target audio boost, built-in speaker and the same electronic performance as the CZ-6 QuickSilver.
Visual target ID: The CZ-5's easy-to-read meter displays seven small-target categories: iron, foil, two types of pull tabs, nickels, zinc pennies and silver, copper and clad coins. When the powerful, dual-frequency, Fourier Domain classification circuitry makes an identification, the needle locks over the appropriate category. No programming, no razzle-dazzle, no nonsense ID.
Three-tone, audio target ID: A low tone means a ferrous or iron target, a medium tone means a pull tab or foil, and a high tone means you've probably found a coin. Plus, a distinctive bell tone alerts you to a big target.
Fourier Domain Signal Analysis: The CZ-5 uses this patented signal analysis system to identify deeper targets in mineralized soil. Two VLF, ground-compensated signals are transmitted, giving the circuitry two signals to analyze, compare and identify.
Pushbutton depth, VCO pinpoint: Just push a button and the volume, pitch and needle rise as you approach your target and peak right over it. The meter gives a depth reading in inches for coin-sized objects. Precision pinpointing couldn't be any easier.
Wet sand operation: Salt water is no problem for the CZ-5. Just flip a switch, re-adjust your ground control, and search that wet sand you never could before.
Audio boost volume control: The lower range of this volume control is like any other you've ever used. But as you increase it above mid-range, loud, shallow-target response remains at a fixed volume while faint, deep-target sounds are amplified.
Pushbutton manual ground adjust: With the CZ-5, you get a quick and easy method of ground balancing. Just hold the coil above ground and push the pinpoint button. Then lower the coil to the ground and set the ground control just below the audio tone. That's all there is to it. No switches, no "beeps" and no bobbing the coil up and down.
Target separation: It's a sad-but-true fact that most gold rings, pull tabs, foil and nickels fall in the same conductivity range, meaning that a metal detector user has to dig a lot of tabs and foil to find any rings or nickels. But not any more. The CZ-5 not only separates the nickels from the trash but the tabs from the trash. It has senarate ID and discrimination categories for round pull tabs, rectangular pull tabs, foil and nickels Rather than a complicated "notch" system, the individual categories are sequentially arranged to ensure maximum good-target recovery. In moderately trashy areas for example, you can set the CZ-5 to reject iron and round pull tabs and still dig nickels, other coins and all gold rings falling into the nickel, foil and rectangular-tab categories. Or in very heavy trash you may wish to eliminate foil as well and still dig rings falling into the rectangular tab and nickel categories. Visual target ID Three-tone
FEATURES
- Visual target ID Three-tone
- Audio target ID Two-frequency
- Fourier Domain Signal Analysis
- Built-in speaker
- Pushbutton depth reading and pinpointing
- Pushbutton ground adjust
- Big-target alert
- Increased depth in mineralized soil
- Turn-on-and-go preset control markings
- Wet-sand mode
- Three-piece break down
- Faint-target audio boost
- Eight-inch, open-center Spider Coil
- Drop-in batteries
- Handle mount or hip mount
- Silent-search, VLF, slow motion discrimination
- Super-hot, wide-scan, all-metal, autotune mode
- Lifetime Warranty - On All Fisher Hobby Detectors
CZ-5 QUICKSILVER SPECI FICATIONS
- Length Extended 51"
- Collapsed 41"
- Weight Complete 3.7 lbs.
- Control Housing 1.5 lbs.
- Handle and Coil 2.2 lbs.
- Frequency . . 1 . Dual, VLF Search. 5 kHz and 1 5 KHz
- 2. Target Response:
- Iron ID 200 Hz (LO)
- Foil and Tab ID. . 450 Hz (MID)
- Coin ID 1 KHz (HI)
- Autotune 500 Hz - 1 KHz (VCO)
- Pinpoint/Depth . 500 Hz - 1 KHz (VCO)
- Operating Modes.... 1 . Autotune VLF-Motion, all-metal with threshold tone
- 2. Target ID VLF-Slow Motion, silent- search discrimination
- 3. Pinpoint/Depth.... VLF, all-metal, no motion
- Batteries . . . Drop-in, no wires . . . . Yes
- Type Two, 9-V Alkaline
- Life 10-20 hours
- Manual Ground Adjust Yes
- Manual Threshold Tuning Autotune mode only
- Wet Sand Operation ..Yes
- Handle Hip mount Yes
- Built-in Stand and Arm Rest Yes
- Audio Output Stereo Headphones . . . Optional
- Speaker Built-in
- Target ID Meter Lock-on, 7 categories
- Tone 3 tones plus bell tone for large, shallow targets
- Faint Target AudioBoost Yes
- Search Coil Type Concentric, Co-planar Spider coil
- Diameter 8"
- Shielding 100% ESI
- Interchangeable Yes
- Submersible Yes
- Warranty: Lifetime Warranty - On All Fisher Hobby Detectors
CONTROLS
DISC. Eight-position potentiometer. Seven pre-set discrimination points plus all-metal autotune position.
PINPOINT. Pushbutton for pinpointing, depth reading and ground balancing (in conjunction with ground control).
SENSITIVITY/BATTERY TEST. Dual function potentiometer
GROUND. Ground-balance potentiometer.
MODE. Two-position switch: "Normal" position and "Salt" position for wet, salt-water beaches.
POWER ON/OFF VOLUME. Dual-function potentiometer and switch. Volume settings above midrange amplify faint, deep-target sounds, limit loud-target responses
ACCESSORIES Standard
Eight-inch Spider coil
with 7-foot cable
Alkaline batteries
Operating manual
Optional
Carrying case
Open and closed coil covers
Five-inch coil
10 1/2-inch Spider coil
Stereo Headphones
Carrying Bag
Holster for Control Housing
|
